Author Topic: Scoped 410?  (Read 748 times)

0 Members and 1 Guest are viewing this topic.

Offline redleg11b

  • GBO Supporter
  • Trade Count: (9)
  • Contributor
  • *****
  • Posts: 251
  • Gender: Male
Scoped 410?
« on: October 11, 2012, 12:52:24 PM »
Am trying to work a trade on a youth 410, but it is scoped.  Are they d/t?  If this was done "professionally" it shouldn't be a concern, but what should I look for when I put my eyes on it.  I was told that it was scoped for a young turkey hunter.  If the trade goes through, I won't want it scoped.  I'll have to find appropriate plug screws I guess.  Thanks for the input.
H&R: .223, 20ga, .357, Sportster LR
Cricket LR

Offline tacklebury

  • GBO Supporter
  • Trade Count: (12)
  • Senior Member
  • *****
  • Posts: 3633
  • Gender: Male
  • Central Michigan
Re: Scoped 410?
« Reply #1 on: October 11, 2012, 04:38:11 PM »
To my knowledge, there has never been a scope mount ready .410.  Even the .45colt-.410 survivor isn't scope ready.  Luckily the .410 has a lot of barrel swell, so if it wasn't bungled very badly, it shouldn't be into the chamber.  I'd make sure to get a look down the chamber area with a good light and make sure that isn't the case.  Lot of people have been putting little red-dot scopes on the lighter kicking shotguns for quick pointing.  Is there still a bead up front or did they cut off the choke too?  If there's no bead, the red-dot might be the way to go.  ;)
 
Something like these might work for decent pricing:
http://www.sportsmansguide.com/net/cb/extreme-tactical-mini-multi-reticle-sight.aspx?a=969716
http://www.sportsmansguide.com/net/cb/browning-buckmark-reflex-sight.aspx?a=691313
 
***ps*** I was 11b also, when were you in?
Tacklebury --}>>>>>    Multi-Barrel: .223 Superlite, 7mm-08 22", .30-40 Krag M158, .357 Maximum 16-1/4 HB, .45 Colt, .45-70 22" irons, 32" .45-70 Peeps, 12 Ga. 3-1/2 w/ Chokes, .410 Smooth slugger, .45 Cal Muzzy, .50 Cal Muzzy, .58 Cal Muzzy

also classics: M903 9-shot Target .22 Revolver, 1926 .410 Single, 1915 38 S&W Break top Revolver and 7-shot H&R Trapper .22 6" bbl.


Offline redleg11b

  • GBO Supporter
  • Trade Count: (9)
  • Contributor
  • *****
  • Posts: 251
  • Gender: Male
Re: Scoped 410?
« Reply #2 on: October 12, 2012, 01:12:56 AM »
The bead is still there, case colored frame, pallet wood stock, and it looks nice.  It's from another forum.  He didn't like my first offer, so I am going to try another.  Thanks for they reply.
H&R: .223, 20ga, .357, Sportster LR
Cricket LR

Offline upnut

  • Trade Count: (3)
  • Avid Poster
  • **
  • Posts: 193
  • Gender: Male
Re: Scoped 410?
« Reply #3 on: October 13, 2012, 09:37:05 AM »
Good advice from Tacleberry, there is plenty of  thickness in the barrel to drill/tap for a scope rail. You might want to check out closely what scope rail was used, and look to see if the hammer was "bobbed" or a hammer spur attached. Depending what you will use it for, a scope can be a good tool for placing that small, expensive shot load exactly where you want it. Here's a pic of my scoped .410, doing exactly what I set it up to do at 40 yards:
 
 

Good Luck!
Scott B.

Offline redleg11b

  • GBO Supporter
  • Trade Count: (9)
  • Contributor
  • *****
  • Posts: 251
  • Gender: Male
Re: Scoped 410?
« Reply #4 on: October 13, 2012, 11:20:58 AM »
I wanted it for my 8 yo to squirrel hint with.  I guess it wasn't in the cards.  I'm still keeping my eyes open though.

That groundhog always carry that plastic around?
H&R: .223, 20ga, .357, Sportster LR
Cricket LR

Offline spikehorn

  • GBO Supporter
  • Trade Count: (84)
  • Senior Member
  • *****
  • Posts: 3000
  • Gender: Male
Re: Scoped 410?
« Reply #5 on: October 16, 2012, 01:22:03 PM »
I had my 410 D/T put a red dot on it
308 win                 45-70                       12ga         
30-30                    223 stainless steel   20ga TDC
44 mag                  Tracker II 20ga        20ga
45-70 Manlicher     20ga USH                28ga
                                                              410ga