« previous next »
Pages: [1]   Go Down

Author Topic: Turret Press for BPCR loading  (Read 443 times)

0 Members and 1 Guest are viewing this topic.

Offline fredj

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 109
Turret Press for BPCR loading
« on: January 17, 2003, 01:48:17 AM »
I'm looking at getting a turret press for my BPC Rifle loading I've
been using a single stage, but the idea of having all the dies
in place, and then just adding turrets for additional calibers seems
quite compelling The Redding looks good as does the Lyman
I'd appreciate any opinions.
fredj
Logged

Offline Dand

  • GBO Supporter
  • Trade Count: (35)
  • Senior Member
  • *****
  • Posts: 2974
I like my Lyman
« Reply #1 on: January 20, 2003, 08:04:28 PM »
My Lyman works well for my smokless loading. The ram is real close to the post though and someone with thick fingers might wish for a little more space.  I wish the rear turret support was more beefy possibly with a bearing but that would probably add lots to the cost.

From what I've seen the Redding should be good.  I seems huge and its pricey.  Haven't seen an RCBS turret press up close but the priming system looks intriguing if you want to prime  on your press.
Logged
NRA Life

liberal Justice Hugo Black said, and I quote: "There are 'absolutes' in our Bill of Rights, and they were put there on purpose by men who knew what words meant and meant their prohibitions to be 'absolutes.'" End quote. From a recent article by Wayne LaPierre NRA

Offline Duke45

  • Trade Count: (0)
  • Member
  • *
  • Posts: 41
Presses
« Reply #2 on: February 14, 2004, 01:53:14 PM »
Fredj  Iuse the rockchucker and also have the Redding t-25 and the Redding t-7 i like them and use them for all calibers. They are very rugged and will last years. Duke45
Logged
AL
Pages: [1]   Go Up
« previous next »