« previous next »
Pages: [1]   Go Down

Author Topic: Pachmayr Decelerator Pad  (Read 527 times)

0 Members and 1 Guest are viewing this topic.

Offline Spokerider

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 144
Pachmayr Decelerator Pad
« on: March 19, 2013, 05:51:20 AM »
I'm looking to replace the factory rubber pad on the rynite contender stock with a Pachmayr Decelerator pad.
 What size fits the contender stock? I'd like one that is 1" thick.
 
Thanks.
Logged

Offline Iowa Fox

  • Trade Count: (7)
  • Contributor
  • ***
  • Posts: 250
Re: Pachmayr Decelerator Pad
« Reply #1 on: March 19, 2013, 12:23:30 PM »
Use a Limb Saver. Its a direct replacement for the rock hard factory rubber pad, fit and screw holes are just right.
Logged

Offline Keith L

  • Moderator
  • Trade Count: (4)
  • Senior Member
  • *****
  • Posts: 3781
Re: Pachmayr Decelerator Pad
« Reply #2 on: March 19, 2013, 01:05:10 PM »
+1 on the limbsaver.  They work great!
Logged
"Beer is proof that God loves us and wants us to be happy."  Benjamin Franklin

Offline Siskiyou

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3417
  • Gender: Male
Re: Pachmayr Decelerator Pad
« Reply #3 on: March 19, 2013, 03:50:07 PM »
I had the red hard rubber butt plate on my 7MM Remington  Magnum replaced with a Decelerator recoil pad.  Made a world of difference and turned my M77 into a useable rifle.
Logged
There is a learning process to effectively using a gps.  Do not throw your compass and map away!

Boycott: San Francisco, L.A., Oakland, and City of Sacramento, CA.

Offline Spokerider

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 144
Re: Pachmayr Decelerator Pad
« Reply #4 on: March 20, 2013, 06:24:22 AM »
I didn't see a listing for a Contender on the Limbsaver website.......just a listing for the Encore, Blackdiamond, Omega #10031
http://www.limbsaver.com/2010/pdfs/templates/10031.pdf
Limbsaver also makes the Nitro grind-away pad. It has a 1.5" length of pull, which I like. It won't have the raised plastic on the back of it to align it into the rynite stock however. It would be just the two screws holding it in place.........wonder if it would work?
http://www.limbsaver.com/firearms/recoil.php#grind
Logged

Offline lepcur

  • Trade Count: (19)
  • Avid Poster
  • **
  • Posts: 203
Re: Pachmayr Decelerator Pad
« Reply #5 on: March 21, 2013, 02:29:20 PM »
X10 on the limbsaver pad. I think it would work and if you have any concerns once it's fitted and your ready to screw it in place you could squirt a little expanding foam in the hollow and screw it down, that stuff is a good bonding agent too.   Mike
Logged
Pages: [1]   Go Up
« previous next »