« previous next »
Pages: [1]   Go Down

Author Topic: Extractor removel and replacement  (Read 493 times)

0 Members and 1 Guest are viewing this topic.

Offline daniel2013

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 229
Extractor removel and replacement
« on: April 21, 2013, 05:21:59 PM »
I posted this on my rear sight removal but I think I should make a thread of it's own to get attention.  Is the procedure pretty much the same with the extractor.  I got a barrel with the wrong extractor and it doesn't reach the rim.  Got a new one coming.  I know their is a small spring under the extractor and to be careful and not loose it.  After punching the pin out will everything pull right out?  Then just reverse the procedure?
Thanks
Danny
Logged

Offline Slowpoke Slim

  • Trade Count: (18)
  • A Real Regular
  • ****
  • Posts: 579
  • Gender: Male
Re: Extractor removel and replacement
« Reply #1 on: April 22, 2013, 02:00:28 AM »
Yeah, that's about it. I put my barrel in my bench vice (with soft jaw inserts in vice) so that I can use both hands to work on the barrel. It's pretty easy to replace.
Logged

Offline daniel2013

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 229
Re: Extractor removel and replacement
« Reply #2 on: April 22, 2013, 08:49:01 AM »
The new extractor came today and I was able to change it with no problem.
Thanks guys
 
Logged
Pages: [1]   Go Up
« previous next »