« previous next »
Pages: [1]   Go Down

Author Topic: CORBIN OR RCE STEP DOWN DIE  (Read 1982 times)

0 Members and 1 Guest are viewing this topic.

Offline Lead pot

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 743
  • Gender: Male
CORBIN OR RCE STEP DOWN DIE
« on: December 05, 2002, 06:07:45 PM »
I need a .458-.450or.449 two stage or single.449 die from Corbin or RCE  for making bore riding bullets.My new rifle has a short throat,the old sharps has a pp throat were I use a 1 ogive but I have to seat the bullet to deep,unless I bore seat the bullet with a seating tool.I want to be able to make a bore rider.
I been making 170 gr.308 with a rebated boat tail( like the Lapua)with good results,they are as good or better than the 168 Siearra match. :D LP.
Logged
Dont go were the path leads,go were there is no path and leave a trail.

Offline Lead pot

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 743
  • Gender: Male
CORBIN OR RCE STEP DOWN DIE
« Reply #1 on: December 06, 2002, 06:33:49 PM »
:D Hi Talon>A bullet reducing die might work,but it would be tapered more than I would want it.A dual diameter die comes in two part which would be adjustable which I want, were I can adjust the ogives lenth for a longer bore riding nose.It workes on both the jacket and lead bullet.I have tapered dies,but I need the longer bore riding one caliber diameter bore riding ogive.I can have one made for about $300,but I thought a used one might be arround not being used.The base diameter should be .459 and the Ogive .449.TNX. for the reply.Lp.
Quote
Do you have to use a silencer to shoot a mine? :roll:
Logged
Dont go were the path leads,go were there is no path and leave a trail.
Pages: [1]   Go Up
« previous next »