« previous next »
Pages: [1]   Go Down

Author Topic: Question on Lyman Molds.  (Read 583 times)

0 Members and 1 Guest are viewing this topic.

Offline Lucky Joe

  • Trade Count: (4)
  • Avid Poster
  • **
  • Posts: 195
Question on Lyman Molds.
« on: April 05, 2004, 04:33:53 PM »
I have a chance to buy a couple of Lyman molds #358101. They cast a very light weight wad cutter. I wonder if anyone here has had any experience with a cast bullet of this type. Also where can I see a list of the molds that Lyman made, I'm not sure of the weight of these bullets and that would help.

Thanks,
Logged
Lucky Joe

"There's always a way."

Offline bpjon

  • Trade Count: (9)
  • Avid Poster
  • **
  • Posts: 124
A good Lyman resource
« Reply #1 on: April 05, 2004, 05:01:29 PM »
http://www.castpics.net/RandD/Lyman_moulds/Lyman_moulds.htm

I hope this helps, it is a very informative site.
Logged
"Who is John Galt?"

Offline Flash

  • Trade Count: (82)
  • Senior Member
  • *****
  • Posts: 2285
  • Gender: Male
Question on Lyman Molds.
« Reply #2 on: April 06, 2004, 06:52:55 AM »
Depending on the alloy, it can be from 70-75 grains. I used to double stack them in my 357 Mag. If you get it priced right, go ahead and get it. You'll like it.
Logged
What doesn't kill us, makes us stronger!
Pages: [1]   Go Up
« previous next »