Author Topic: Invector and Invector Plus Choke Tubes??? (Read 501 times)

lostinvt · « **on:** April 17, 2004, 04:29:05 PM »

Whats the difference and can Invector Plus be used in Invector barrels?? Thanks for the help. LIV

Geno · « **Reply #1 on:** April 18, 2004, 03:15:33 AM »

see Brownings web site :

http://www.browning.com/faq/detail.asp?ID=150

Q. What are some of the differences in Browning choke tubes?
A. The Invector, or ""Standard Invector" system" was introduced in 1983. A few years later, the Invector-Plus chokes were introduced to fit the new back-bored shotgun barrels. These two choke systems will not interchange. If you have screw-in chokes in your shotgun barrel, the kind of system you have will be stamped on the barrel near the receiver. You must use the proper choke system for your shotgun.

Graybeard · « **Reply #2 on:** April 18, 2004, 05:17:28 PM »

The Invector Plus is physically longer than the original. I believe I recall that the originals are the same as those used in Winchester guns.

GB

Bob_K · « **Reply #3 on:** April 19, 2004, 12:26:19 PM »

GB is right. The standard Invector interchange with the Winchester choke, and also the Mossberg. The Invector+ is dimensioned for the .740 ID bore Brownings, and, even if they did fit the standard .729 bore barrels, would not give you the pattern marked on the tube.