open sightson an 1895 c.b. in 45-70 for elk

[gallatin]

I'm new to this gun, like it a lot. Will use it as my elk gun this fall
I would like to here input on receiver mounted aperture type sight that does not require the change of the front sight. It seems that a new front sight would not then allow the use of the factory open sight in an emergency. Also it seems that 400+gr. loads of hard cast lead fly higher than copper jacketed bullets of simular weight.
Your thoughts

[Mikey]

gallatin:  the installation of an open or peep or aperature receiver mounted rear sight most often involves the use of a higher front sight and negates the use of the barrel mounted rear sight.  Many shooters simply remove the barrel mounted rear sight when installing a receiver mounted sight.  I just lay mine down.

As to the higher point of impact with the 400 gn cast over the jacketed bullets - this happens with cast bullets.  They take to the bore better than the jacketed bullets do and often give you better velocity and greater accuracy than the jacketed loads with the same powder charges.  It is one of those benefits you need to get used to when shooting cast bullets.  HTH.  Mikey.

[Blackhawk44]

Changing that front sight can be a major plus.  Order one of the XS white stripe blade sights.  With the square blade, windage and elevation are clearly defined compared to a bead.  The white stripe at a 30` angle gathers light and shows up in dim light far better than any bead ever has.  After using one for a year, I've just ordered three more.

[DON IN VA]

:-)
I have one of those rifles on which I mounted the vernier tang sight mfg. by Lyman.  It works great at all ranges from close in on out using the existing front sight.  Dab a little white out or use one of the white paint sticks to paint the bead to help during lower light conditions.  The only problem is getting used to laying your thumb along side the sight rather than across the tang as is the normal hold.