CZ 452 trigger creep adjustment

[Questor]

http://projects.chatrifleclub.org/cz452mods.html

CZ is also advertising a stripped down model that does not have an adjustable trigger.  This model may be what is being discussed as a candidate for the third party trigger update kit.  If you've got a non-stripped-down model, you can use the instructions in the manual or in the link above to remove trigger creep.

[ftstinyc]

I have the Eric Brooks kit in my CZ and it is excellent. You don't have to
remove the sear pin to install it. This does away with chasing the little ball.
Very easy to install and gives you an excellent trigger. Brooks is a
sponsor over at Rimfire Central. You can get the information off of his
web-site. There is also a lot of good information about the CZ rifle. He
also sells other accessorys for your rifle and he is very good to deal with.

[Tom C.]

I took apart my CZ 452 to improve the trigger. I installed a spring from the Brooks spring kit, but it also needed more work. I stoned and polished the critical surfaces. It is much better now. I did loose the little ball and had to come up with a replacement.

[ftstinyc]

Did you use the sleeve on the trigger pin? If so you should not of had to
stone the sear. I used the red sleeve and the 2nd stiffest spring and the
trigger has no creep and is about one and a half to two pounds. The
sleeve eleminates the creep. I found with the thinner sleeve I still had a
little creep so i put the thicker one on and it is just fine.