Author Topic: WLP primers (Read 404 times)

wild willy · « **on:** December 14, 2004, 03:55:18 PM »

any body having trouble with wlp being too small I use a RCBS APS tool and when I loaded the strips some of them just fell out .I primed some 44 mags with them not much resitance seating them.I measured some at .209 to .2095. federal and cci measured .210 to.215 any body have any Winchesters they could measure see if they are all small or I just got a bad box

Leftoverdj · « **Reply #1 on:** December 15, 2004, 06:44:21 AM »

Willy, any chance you got an old box? There were a lot of such complaints just after Win stopped plating primers, but I have not heard any lately and my WLPs load fine.

I'll try to remember to measure for you when I get out in the shop.

RickG · « **Reply #2 on:** December 15, 2004, 07:13:34 AM »

Measured several WLP .210 or .211 measured 10; 5 of each size.

Rick

Questor · « **Reply #3 on:** December 15, 2004, 08:19:02 AM »

I don't have my stuff handy, but I get the same resistance from my priming tool with CCIs and WLPs for 45ACP. It could be your brass. Some brass is looser than others. I use WLPs almost exclusively now for 45ACP and they have been fine for years. The only problem I had was a few primers that failed to detonate from one box I had about two years ago.

wild willy · « **Reply #4 on:** December 15, 2004, 08:42:41 AM »

Have no way of knowing how long the store had them .I'll try another store make sure it's a different lot number glad I only bought 100 usually buy a 1000 at a time Thanks for the help
Bill

Duffy · « **Reply #5 on:** December 17, 2004, 04:43:57 PM »

So far have not had any problems with the WW. Did have some CCI's from the 80's that were a bit large though. Kinda crunched when ya seated them.