« previous next »
Pages: [1]   Go Down

Author Topic: Look at my homemade cleaning rods for cas  (Read 585 times)

0 Members and 1 Guest are viewing this topic.

Offline DB Leath

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 386
Look at my homemade cleaning rods for cas
« on: February 02, 2003, 12:19:29 PM »
Logged
SASS #49681
SBSS #1201
Ya have to back your brothers play

Offline ButlerFord45

  • Moderators
  • Trade Count: (10)
  • Senior Member
  • *****
  • Posts: 1992
  • Gender: Male
Look at my homemade cleaning rods for cas
« Reply #1 on: February 02, 2003, 12:24:32 PM »
I still like the fletching!  Make'em go straight down the bore!  
If the rifleing twist is the opposite direction, will it cause it to stop mid bore?   It is a great idea, ya done good
Logged
Butler Ford
He who does not punish evil, commands it to be done.-Leonardo da Vinci
An armed society is a polite society-Robert A. Heinlein
Only the dead have seen the end of war- Plato
Lord, make my words as sweet as honey
tomorrow I may have to eat them- A lady's sweatshirt

Offline Old Cane

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 470
    • http://ee.1asphost.com/OldCane/
Look at my homemade cleaning rods for cas
« Reply #2 on: February 03, 2003, 02:37:31 AM »
Is the jag threaded? How did you do that?
Logged

Offline DB Leath

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 386
cleaning rod
« Reply #3 on: February 03, 2003, 08:20:56 AM »
I used a spare Dewey rod adapter the one you use to put a bore brush on.
I cut the field tip off flush the drilled it the size of the brush adapter. Then epoxied the whole thing to the rod.  I hammered the adapter into the arrow shaft a little ways too...  
I will need to find better looking handle material but it works I used it yesterday....
Logged
SASS #49681
SBSS #1201
Ya have to back your brothers play

Offline T. Two Dogs

  • Trade Count: (0)
  • Member
  • *
  • Posts: 33
Look at my homemade cleaning rods for cas
« Reply #4 on: February 12, 2003, 10:42:59 AM »
Very Cleverly done.  I have several Wooden shafts, some with fletching, some without.  A very wise and economical use for these old shafts.
Logged
Pages: [1]   Go Up
« previous next »