« previous next »
Pages: [1]   Go Down

Author Topic: modifying G2 Contender forearms for Bullberry or VVCG hanger  (Read 590 times)

0 Members and 1 Guest are viewing this topic.

Offline Graycg

  • GBO Supporter
  • Trade Count: (74)
  • Senior Member
  • *****
  • Posts: 1030
modifying G2 Contender forearms for Bullberry or VVCG hanger
« on: May 22, 2005, 03:32:08 PM »
Does anyone know who will alter factory G-2 forends for use with Bullberry or VVCG hanger bars?  I have a custom one, but would like a factory style that fits my hanger bars.

regards,
 graycg
Logged
"Secretly you want me on that wall; you need me on that wall"  
 Colonel Nathan Jessup

Offline skb2706

  • Trade Count: (5)
  • Senior Member
  • *****
  • Posts: 1428
modifying G2 Contender forearms for Bullber
« Reply #1 on: May 23, 2005, 03:46:57 AM »
Georgia Jim can probably did it but you will end up with a total of three holes in the bottom. Two from the original mounting and a new one for the hanger bar. I had considered this too and opted for a new foreend instead.
Actually one of my employees and I are working on making a foreend for my Contender this afternoon. This will be for a hanger bar setup so the tooling we have just working on the setup.
Logged

Offline Catfish

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2696
modifying G2 Contender forearms for Bullber
« Reply #2 on: May 23, 2005, 01:07:31 PM »
Why waist the monet????? Just get a block of wood, I used walnut, and make your own, it`s not that big of a deal.
Logged
Pages: [1]   Go Up
« previous next »