Author Topic: A little of topic but I am curious (Read 594 times)

DB Leath · « **on:** February 13, 2003, 07:20:53 AM »

Hey anyone else ever buy a gun off the net. Get if after waiting and start looking at it. Man this thing is nasty. I havent had trouble with anyone here. I got one from another classified area I wont mention and I am still trying to get it cleaned up.
How do you get the carbon build up out of the cylinders of a revolver?
DB

Jax Orebetter · « **Reply #1 on:** February 13, 2003, 08:46:01 AM »

Howdy DB,

YOu might want to try a tornado brush chucked onto a drill at low speed with your favorite solvent. I did this with a little S&W Jframe that was real dirty. Worked like a charm.

Shootin' Carts Jimmy · « **Reply #2 on:** February 13, 2003, 10:10:44 AM »

What Jax Said! You can also look at Brownells.com - I think they have brass brushes or screens that are used for this.

I found on my RV and two mileniums that the buildup in the cylinder does not affect accuracy and due to the amount of elbow grease required to remove it, I just leave it alone.

DB Leath · « **Reply #3 on:** February 13, 2003, 10:38:12 AM »

Jimmy did I buy this one from you. I dont think this guy cleaned his either.

Cheyenne Ranger · « **Reply #4 on:** February 13, 2003, 12:34:55 PM »

Bought a couple of guns off the net. The new ones don't count on being dirty. The Win 97 was clean, old but clean.
CR

Shootin' Carts Jimmy · « **Reply #5 on:** February 13, 2003, 04:05:49 PM »

I didn't say I don't clean em! I clean my guns after each outing and get tons of razzing about it from my pards. I also break them down after every 3 or 4 shoots to get the gunk out from the innards. I just don't kill myself over the small stuff like carbon buildup in the cylinder. I actually heard somewhere that it helps seal the case against the wall and helps with accuracy. Mine builds up carbon right where the brass and lead meet - must be from the initial boom of the cartridge. Or maybe its just rationalization. wow that's a big word

Jose Grande · « **Reply #6 on:** February 13, 2003, 07:42:44 PM »

A friend helped me sell a couple on the wire. No problems. Just give an accurate discription & pics if possible. :-)

Rifled Slug · « **Reply #7 on:** February 14, 2003, 01:46:08 AM »

Howdy ,
That build up in your cylinders isn't a problem if you shoot the same lenght cartridges all the time . But if you shoot say 44 spl for some time and then decide to shoot some 44mags they may not go all the way into the chamber .

Cuts Crooked · « **Reply #8 on:** February 14, 2003, 03:09:35 AM »

Just lucky I guess! I've bought several guns over the net and have never been disappointed with any of them.

The most recent one I purchased this way was bought from a feller out in Oregon and had minor surface rust inside the magazine tube, to be expected in that climate, but it was easily removed and had no affect of the guns looks or functioning!