Author Topic: magtech bullets (Read 661 times)

ted · « **on:** April 25, 2005, 03:25:13 PM »

I just purchased some 158 gr. jsp bullets, .357 caliber.They were inexpensive enough I figure I would try them once. Anybody try these or other magtech bullets and if so, what did you think?

Redhawk1 · « **Reply #1 on:** April 26, 2005, 02:04:30 AM »

I found the cases split a lot. I have shot the 454 Casull from Magtech. I won't reload there brass.

narvous · « **Reply #2 on:** April 26, 2005, 08:41:23 AM »

:grin:

Redhawk1 · « **Reply #3 on:** April 26, 2005, 09:44:14 AM »

Sorry :oops: I read your post again and you were talking about there bullets. No I have not tried there bullets.

ted · « **Reply #4 on:** April 26, 2005, 10:37:53 AM »

Yes, I was talking about the bullets but, thanks for the info about the brass as I found that very helpful. I have been using starline brass and found it to be very good.

Jim n Iowa · « **Reply #5 on:** April 26, 2005, 01:45:16 PM »

I have bought there 44 mag ammo with 240 jsp for hunting and shooting. I needed to build up a supply of cases for reloads also. Have had no problems with the cases in reloading warm 240 jacket and hard cast loads, some have cycled 3x.
Jim

De41mag · « **Reply #6 on:** April 26, 2005, 03:20:13 PM »

I've heard from a very reliable source that they use more of the harder metals and less copper in their jackets which could lead to premature barrel wear. That is why their bullets have a orange tint to them other than a copper appearance.
Just what I was told.

Dennis

Old Griz · « **Reply #7 on:** April 29, 2005, 03:57:22 AM »

:cb2: My only experience has been with their .44 mag. ammo, and it realy shoots great in the guns I have tried them in. Would readily hunt with them if I had to.

AZ223 · « **Reply #8 on:** May 14, 2005, 09:32:04 AM »

I've used their ammo in my .45 ACP; clean, very accurate and no jams. Good inexpensive target ammo. I don't reload that caliber yet, so I can't speak for the brass.