« previous next »
Pages: [1]   Go Down

Author Topic: Dirty Cases  (Read 319 times)

0 Members and 1 Guest are viewing this topic.

Offline vanbuzen9

  • Trade Count: (16)
  • Avid Poster
  • **
  • Posts: 197
  • Gender: Male
Dirty Cases
« on: May 18, 2005, 05:14:33 AM »
Hello,

I just got done reloading a batch of 9mm cases. For some reason, there was alot of black stuff on the outside of the cases.  I have heard that this could be caused by an under-powered load. (not expanding enough to seal the gases).  Using 100 grain hornady bullets on top of 5.7 grains power pistol.  Any suggestions or insite would be great.

thanks,
vanbuzen9
Logged

Offline RickG

  • Trade Count: (0)
  • Member
  • *
  • Posts: 18
Dirty Cases
« Reply #1 on: May 18, 2005, 10:33:18 AM »
VanB9

Check your crimp if it's not crimped enough the bullet leaves before the pressure builds and allows blowback.  You'll probably always have some "black stuff" on the case.

Rick
Logged

Offline KN

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1962
Dirty Cases
« Reply #2 on: May 18, 2005, 11:35:11 AM »
Incomplete ignition can cause this also. Such as using std primers with H110. Basically you are correct that the cases are not expanding enough.  KN
Logged
Pages: [1]   Go Up
« previous next »