« previous next »
Pages: [1]   Go Down

Author Topic: Stock Washers  (Read 306 times)

0 Members and 2 Guests are viewing this topic.

Offline springer222

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 191
Stock Washers
« on: July 01, 2005, 04:02:13 PM »
Hey machinist's and/or T/C 'smith's-

Where can I find the special "flat" washers used on the grip/stock screws? They have the standard ID for 1/4" bolts but the OD is ~.500" and they are ~.065" thick. I looked in a McMaster catalog but I wasn't sure what I was looking for - are they specifically made for T/C use or can I find them thru a merchandise supplier? Thanks!
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Stock Washers
« Reply #1 on: July 01, 2005, 07:19:05 PM »
I think I'd just give TC's service folks a call.  They've been pretty  good to deal with before and are usually out to please.  One could likely make a washer to fit,  but why bother..?
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."
Pages: [1]   Go Up
« previous next »