Evening!
I don't spend much time writing on this thing. I post a range report on occasion, but that is about it.
Thought it was time I thanked all who post there problems with the H&R products. Probably the results they get from trying different ways to solve a problem is something a book could be written about. Posting the results good or bad helps us all.
Today I started to install my new Smith Ladder sight on my B.C. Looking down into the screw holes reminded me about crud and gunk that gets left in them when they are drilled. Sure enough after about a half hour of work they were both cleaned out and the sight installed. No problem. If it had not been for a discussion on this subject I would still be cussing.
AGAIN, THANKS GUYS.
Escalante.
