Author Topic: What Size Sims Recoil Pad? (Read 494 times)

35Rem · « **on:** August 12, 2005, 05:34:24 AM »

Hey guys,

What size Sims Limbsaver Gring to Fit recoil pad do I need??

I have a new Handi in 45-70. Straight stock?

Anyone installed one of these on this stock? Any Tips??

Thanks...

quickdtoo · « **Reply #1 on:** August 12, 2005, 05:42:38 AM »

Small...haven't installed it on a straight stock, but I've installed a couple on monte carlos. I just grind the base then taper the sides, leaving the full contour for recoil absorbtion.

Tim

slayer · « **Reply #2 on:** August 13, 2005, 03:39:04 PM »

On that same note, which one for the H&R .45/70 Buffalo? Thanks-JaCK.

quickdtoo · « **Reply #3 on:** August 13, 2005, 04:46:18 PM »

Small....after you cut the cup off the stock... :wink: The small slip on works too, but is loose.

Tim

slayer · « **Reply #4 on:** August 14, 2005, 01:47:13 AM »

Thanks Tim, definitely going for the Small Slipon, it`s just for sighting in at the bench

Cutting the cup off

Jack.

quickdtoo · « **Reply #5 on:** August 14, 2005, 05:34:57 AM »

If you want a nice looking slip on recoil pad that fits better than the Sims, try the small Galco....it won't be as effective as the Sims, though.

Galco

slayer · « **Reply #6 on:** August 14, 2005, 10:52:03 AM »

Ah, that`s a nice one, but a little pricey? What size is that one? How much are the Sims around? Thanks Tim-Jack.

quickdtoo · « **Reply #7 on:** August 14, 2005, 11:43:19 AM »

That Galco is a small. The Sims sell for $24...

35Rem · « **Reply #8 on:** August 14, 2005, 11:52:56 AM »

The small Sims is at my local Walmart's (2) for just under a $20 bill....