Author Topic: Point of impact change when changing power on a variable?  (Read 1055 times)

0 Members and 2 Guests are viewing this topic.

Offline lilabner

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 577
Point of impact change when changing power on a variable?
« on: November 12, 2005, 07:16:40 AM »
It is widely reported that the new generation of variable power scopes are pretty much free of serious defects. Have you sighted in using high magnification on a scope of recent manufacture and found that point of impact changed when you shifted to a lower power setting for hunting? If so, what scope and how much shift?

Offline Redhawk1

  • Life time NRA Supporter.
  • GBO Supporter
  • Trade Count: (78)
  • Senior Member
  • *****
  • Posts: 10748
  • Gender: Male
Point of impact change when changing power
« Reply #1 on: November 12, 2005, 12:27:05 PM »
I have never experienced that. If you sight in on high power you are sighted in at low power. You are not moving the cross hairs, just the magnification.

What might be happening is, at longer ranges you may not hold on the say spot you would if you used high magnification.  :D
If  you're going to make a hole, make it a big one.
ΜΟΛΩΝ ΛΑΒΕ
Only two defining forces have ever offered to die for you,
Jesus Christ and the American G. I.
One died for your soul, the other for your freedom

Endowment Life Member of the NRA
Life Member NA

Offline moontroll

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 102
Point of impact change when changing power
« Reply #2 on: November 13, 2005, 04:18:00 PM »
I had it happen on a Zeiss Conquest,it would shift 2" to the left and 2" down from the higest setting to the lowest.I sent it in and they sent me a brand new one.

Offline moontroll

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 102
Point of impact change when changing power
« Reply #3 on: November 13, 2005, 04:19:49 PM »
I had it happen on a Zeiss Conquest,it would shift 2" to the left and 2" down from the higest setting to the lowest.I sent it in and they sent me a brand new one.

Offline lilabner

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 577
Point of impact change when changing power
« Reply #4 on: November 14, 2005, 05:25:10 AM »
Most hunters set the scope at a lower magnification when hunting to get a wider field of view if game is seen at close range. In my experience, many shooters go to high magnification to sight in from the bench, which makes sense because you get a much better sight picture on the bullseye. However, my experience as a range officer has been that quite a few shooters do not confirm their zero by shooting a group or two at the lower magnification they'll be using in the field. I've not had a problem with wandering zero with my scopes but it apparently exists.

Offline victorcharlie

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3573
Point of impact change when changing power
« Reply #5 on: November 14, 2005, 06:29:48 AM »
I know the problem existed in the 60's.....but think that for the most part on the more modern, mid to higher priced scopes produced say from 1983 on.....the POI doesn't shift enough to be a factor for anything other than benchrest, or long range shooting.........but in my mind, the more moving parts the greater the odds of this type problem occurring.........I've come to the opinion that a fixed 4X is plenty on a big game rifle, and am slowly going to be replacing everything but Leupolds and Bushnell Elites with fixed powers.........I think a good heavy barrel varmit rifle can stand a higher powered scope for long shots on small critters.........From my experience at the range, my groups from a 4X are very close to the same as with the scope set to 12X or 16X ....at a hundred yards.............but believe the additional field of view from the lower powered scopes are more beneficial in the field...........where most of my shots are 100 yards or less........
 
I wouldn't bet on the lower end lines.............Seems most of the low end scopes start good but don't hold up for any length of time, at least they haven't for me..............Ain't gonna call no names......
"Extremism in the defense of liberty is no vice. Tolerance in the face of tyranny is no virtue."
Barry Goldwater