The cap and ball revolvers Cabelas stock are mainly Pietta and Uberti products. Both are reasonably good quality, and should give good service. If you buy one from their bargain cave, it could well be one that was returned because of problems, so look it over careful. Cock it a few times, to be sure it functions smoothly, and locks up tight. Also watch the cylinder latch, to make sure it is timed correctly. Some of them are timed so poorly, that the latch is released almost as soon as the cylinder starts to move, and results in a ring worn around the complete circumference of the cylinder. If you have more than one to choose from, pick the one that releases the latch closest to the mortise in the cylinder. Make sure the loading lever operates smoothly, and the hammer sits squarely in it's mortice, without hitting on one side or the other. That is about all you can tell, without shooting them. Other than that, it is all a matter of personal preference. Pick the one you like the best ! You will need a powder flask with the correct spout for the caliber, and a capper, then read other threads on this forum for safety tips on how to avoid chain fires, and other pitfalls. There is a lot of good information posted on this forum, by old hands who are expert on these fun old designs, and you can find out everything you will need to know, just by reading. If you are like most of us, this will be the first of many cap and ball revolvers that will soon have you building a new cabinet to keep them all in. Have fun !
