« previous next »
Pages: [1]   Go Down

Author Topic: .454 brass to .45 Colt?  (Read 283 times)

0 Members and 1 Guest are viewing this topic.

Offline volshooter

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 319
.454 brass to .45 Colt?
« on: December 14, 2005, 02:38:15 PM »
I have plenty of .454 Casull brass but have traded the pistol. Anyone have thoughts on cutting these down to .45 Colt? I know a small pistol primer will have to be used but I do think the strong Casull case would last a lifetime shooting low/midrange loads.

Any comments welcome, rick
Logged

Offline Cowpox

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 456
  • Gender: Male
.454 brass to .45 Colt?
« Reply #1 on: December 14, 2005, 03:03:43 PM »
I would think that .454 trimmed to Colt length would be lacking some case capacity, due to having a beefed up case head to handle the higher pressure of the Casull. I would sure test one for capacity before cutting them all. It might be better to clean it up, and take it to a swap meet or gun show, and trade it for .45 Colt brass, or any other kind you can use.
Logged
I rode with him,---------I got no complaints. ---------Cowpox

Offline Steve P

  • Trade Count: (10)
  • Senior Member
  • *****
  • Posts: 1733
  • Gender: Male
.454 brass to .45 Colt?
« Reply #2 on: December 14, 2005, 04:03:50 PM »
You can trim some brass down with no problem.  Other brass may be straight wall on the outside with a slight taper on inside.  As you trim it down the thickness starts to show.  The brass may be too thick to seat a bullet and still chamber without doing some "neck turning".

It would probably be lots faster and easier to go to local gun store or gun show and trade for 45 colt.

Steve   :D
Logged
"Life is a play before an audience of One.  When your play is over, will your audience stand and applaude, or stay seated and cry?"  SP 2002
Pages: [1]   Go Up
« previous next »