I have had this rifle for about a month. I shot some winchester whitebox 45grain jhp thru (The gun grouped them really well). Took brass and FL resize to make some reloads. Trim to length 1.906. Reamed and deburred brass then wiped clean. I then tried casing in chamber to see if breech would close. It was a no go. Gun would not close. All my new casings and shells close no problem. The only problem I can tell is these casings are not going in chamber all the way ( not flush with barrel). After feeling these casings they appear to have slight bump where extractor notch is. If I turn them to where the bump lines up with notch I can get the gun to close with a little force and they feel closer to flush but not quite. With this happening I have some brass that I cant reload. I would really like to try some reloads in this gun but scared to waste the brass. This cant be normal because my 223 Ultra Varmint with the ejector has no problems. Any suggestions is very much appreciated.
Thanks
