Author Topic: yugo 48 rebarrel (Read 665 times)

vjrhunter · « **on:** April 08, 2006, 06:16:10 AM »

Any problems,issues with rebarreling a yugo 48, or is it just like doing a 98?

gunnut69 · « **Reply #1 on:** April 08, 2006, 10:55:59 AM »

A yugo M48 is a M98 action. What kind of issues were you thinking of.. All mausers should be carefully checked before rebasrreling and I like to check for signs of abuse and lug setback.

Racepres · « **Reply #2 on:** April 08, 2006, 12:50:53 PM »

The yugo being an intermediate length, large ring, You may find that the barrel has an extractor "cut-out" . These are probably not necessary, but you may want to check for extractor face clearance [to the barrel] . Usually if there is contact, thinning of the extractor will be sufficient to provide clearance. But, I hear of people cutting small extractor reliefs in the barrel. The 48/24-47 actions should be ideal for 308 length ctg.s I think... Good luck w/ it . MV

vjrhunter · « **Reply #3 on:** April 08, 2006, 04:19:12 PM »

thanks for the replies.I was concerend about the extractor cut. looking to find a 48 to build a 7mm/08

Longrider · « **Reply #4 on:** April 08, 2006, 07:53:23 PM »

S.O.G. has Yugo M 24/47's in their latest flyer. Same as the M-48 and all milled parts. M-48A has a stamped trigger guard and mag. follower.

Racepres · « **Reply #5 on:** April 09, 2006, 03:48:50 AM »

Quote

S.O.G. has Yugo M 24/47's in their latest flyer.

But I would not sporter one of those! Not while sarco and century have actions only, and barreled actions. Less $$ less labor, less "stigma".etc... $0.02. MV
BTW I will be starting such a project [m48 in 308 Target] tomorrow if you would like a chronicle of progress.

vjrhunter · « **Reply #6 on:** April 09, 2006, 10:40:24 AM »

sarco is sold out of mauser actions