« previous next »
Pages: [1]   Go Down

Author Topic: Another one for a Mauser Gunsmith  (Read 625 times)

0 Members and 1 Guest are viewing this topic.

Offline GeoW

  • GBO Supporter
  • Trade Count: (0)
  • Member
  • *****
  • Posts: 23
Another one for a Mauser Gunsmith
« on: June 10, 2006, 01:11:16 PM »
Hi,
I recently lucked into a JC Higgins branded Model 50 FN Mauser. It is a pre-serial numbered model and appears to be unfired. Ordered a set of Weaver steel bases and find that the rear base with the standard .5 inch hole spacing does not fit the rear hole spacing of the receiver. The receiver is drilled at 7/16 inch between centers as best as I can measure. Anyone seen this before or have advice or ideas? I did read that Conetrol makes a 7/16" base to fit but I'm hoping to find a Weaver type base.
Thanks,
George
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Another one for a Mauser Gunsmith
« Reply #1 on: June 11, 2006, 09:17:51 AM »
Call the Brownells hot liine and ask for tech-support.. They are at the toll free number below. There are mauser bases for several different mauser actions. What number are the boses you have?

Brownells--- 800-741-0015
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline GeoW

  • GBO Supporter
  • Trade Count: (0)
  • Member
  • *****
  • Posts: 23
Another one for a Mauser Gunsmith
« Reply #2 on: June 11, 2006, 04:12:30 PM »
I have the Weaver S45 and S46 bases that are called for for this particular rifle. I got these from Brownells, will call them tomorrow.
Thanks,
George
Logged
Pages: [1]   Go Up
« previous next »