« previous next »
Pages: [1]   Go Down

Author Topic: do encores shoot loose?  (Read 629 times)

0 Members and 1 Guest are viewing this topic.

Offline hipshot300

  • Trade Count: (0)
  • Member
  • *
  • Posts: 56
do encores shoot loose?
« on: August 28, 2006, 12:15:42 PM »
Over on the nef side, a discussion came up a couple of times about the handi "shooting loose" and requiring a shim to tighten things up. Is this a problem with all break over designs? Have any encores shot loose with high pressure rounds over time?
Logged

Offline Redhawk1

  • Life time NRA Supporter.
  • GBO Supporter
  • Trade Count: (78)
  • Senior Member
  • *****
  • Posts: 10748
  • Gender: Male
Re: do encores shoot loose?
« Reply #1 on: August 28, 2006, 03:33:57 PM »
Not any of the ones I have, I even had a 416 Rigby barrel on one of mine.
Logged
If  you're going to make a hole, make it a big one.
ΜΟΛΩΝ ΛΑΒΕ
Only two defining forces have ever offered to die for you,
Jesus Christ and the American G. I.
One died for your soul, the other for your freedom

Endowment Life Member of the NRA
Life Member NA

Offline Grumulkin

  • Trade Count: (33)
  • Senior Member
  • *****
  • Posts: 2028
    • http://www.orchardphoto.com
Re: do encores shoot loose?
« Reply #2 on: August 29, 2006, 12:55:43 AM »
A small piece of a forend broke under 375 H&H Mag recoil.where one of the forend screws went in for me.  It was replaced promptly by T/C at no charge.

You need to Locktite scope base screws on the Encore if you don't want them to loosen but I think this is true of any rifle.

The above are the only things on an Encore that have shot loose for me and I shoot Encores a lot with pretty much always with full house loads.
Logged
Pages: [1]   Go Up
« previous next »