« previous next »
Pages: [1]   Go Down

Author Topic: how to sweat solder?  (Read 574 times)

0 Members and 1 Guest are viewing this topic.

Offline horseman308

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 159
how to sweat solder?
« on: September 06, 2006, 04:38:15 AM »
I've got a Ruger #1-B, w/o iron sights. I'm planning on putting some on it, and I wondered what the process for sweat soldering the front sight to the barrel is. Is it something the average guy can do or do I really need to take it to a gunsmith? Are there other methods besides this type of soldering that are equally or more effective?
Logged
You only take one shot at a time, so don't waste it :cb2:

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: how to sweat solder?
« Reply #1 on: September 06, 2006, 08:38:55 AM »
Sweating is not really hard to do but is a fairly complex task. Almost all sights are screwed to the barrel and it's what I suggest. Firstly a call to Ruger service might be in order. Perhaps they can help. Otherwise a sight and ramp setup can be ordered from Browells.. The Ruger front ramp is a barrel band and is retained by a set screw. Good luck!!
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."
Pages: [1]   Go Up
« previous next »