« previous next »
Pages: [1]   Go Down

Author Topic: Breaking in a new barrel?????  (Read 814 times)

0 Members and 1 Guest are viewing this topic.

Offline Skeeno

  • Trade Count: (0)
  • Member
  • *
  • Posts: 6
Breaking in a new barrel?????
« on: August 30, 2006, 06:10:28 AM »
Hi all,

Been browsing through the forum for quite some time now.  I have learned quite a bit from everyone here and now I have a question.

 I just purchased a new rifled slug barrel for my 870.  Is there anything I need to do to break it in?  I have read other posts on breaking in a barrel, but they all seemed geared toward rifles.  Since I will obviously be shooting sabots, and the only thing coming into contact with the rifling is the plastic sleeve, is it necessary?  Any and all help, suggestions, or thoughts would be greatly appreciated!  Thank you in advance.

Skeeno
Logged

Offline Redhawk1

  • Life time NRA Supporter.
  • GBO Supporter
  • Trade Count: (78)
  • Senior Member
  • *****
  • Posts: 10748
  • Gender: Male
Re: Breaking in a new barrel?????
« Reply #1 on: August 30, 2006, 06:24:04 AM »
Quote from: Skeeno on August 30, 2006, 06:10:28 AM
Hi all,

Been browsing through the forum for quite some time now.  I have learned quite a bit from everyone here and now I have a question.

 I just purchased a new rifled slug barrel for my 870.  Is there anything I need to do to break it in?  I have read other posts on breaking in a barrel, but they all seemed geared toward rifles.  Since I will obviously be shooting sabots, and the only thing coming into contact with the rifling is the plastic sleeve, is it necessary?  Any and all help, suggestions, or thoughts would be greatly appreciated!  Thank you in advance.

Skeeno

Just go shoot it, I do that with my rifles and handguns. I am not a competition shooter and don't need all bullets to go in one hole.  I have rifles that will shoot sub MOA at 100 yards and I never did a barrel break in. In my opinion it is not needed.

Also welcome to GB... ;D
Logged
If  you're going to make a hole, make it a big one.
ΜΟΛΩΝ ΛΑΒΕ
Only two defining forces have ever offered to die for you,
Jesus Christ and the American G. I.
One died for your soul, the other for your freedom

Endowment Life Member of the NRA
Life Member NA

Offline jrfrmn

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 178
Re: Breaking in a new barrel?????
« Reply #2 on: September 07, 2006, 04:55:00 PM »
Quote from: Skeeno on August 30, 2006, 06:10:28 AM
Hi all,

Been browsing through the forum for quite some time now.  I have learned quite a bit from everyone here and now I have a question.

 I just purchased a new rifled slug barrel for my 870.  Is there anything I need to do to break it in?  I have read other posts on breaking in a barrel, but they all seemed geared toward rifles.  Since I will obviously be shooting sabots, and the only thing coming into contact with the rifling is the plastic sleeve, is it necessary?  Any and all help, suggestions, or thoughts would be greatly appreciated!  Thank you in advance.
                     Shoot it.
Skeeno
Logged
Pages: [1]   Go Up
« previous next »