« previous next »
Pages: [1]   Go Down

Author Topic: Reloading 45-70 & 500 S&W ?  (Read 397 times)

0 Members and 1 Guest are viewing this topic.

Offline dave hall

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 417
  • Gender: Male
  • The Great .458
Reloading 45-70 & 500 S&W ?
« on: October 11, 2006, 03:48:08 PM »
I'm going to start reloading the 45-70 in my new NEF Handi out of my Barnes book.Can you use the Marlin 1895 data for the NEF. Can you get more proformance out of the 500 Handi reloading for the rifle,or is the factory hand gun loads as hot as you can get.One more question why don't they make a 450 Marlin barrel for the NEF Handi.Thanks,Dave.
Logged
NEF Handi SB2  .45-120 Sharps.
Stoeger Coachgun 20 Ga.
Ruger  SP101 4.2"  .357 Mag.
Rossi Ranch Hand (Mares Leg) 45 LC

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Reloading 45-70 & 500 S&W ?
« Reply #1 on: October 11, 2006, 04:11:46 PM »
Marlin loads are safe in a Handi. They do make the .450M barrel for em, it's part #845.

Tim

http://hr1871.com/Support/accessoryProgram.aspx
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Swampman

  • Guest
Re: Reloading 45-70 & 500 S&W ?
« Reply #2 on: October 11, 2006, 04:25:17 PM »
Even the .500 S&W factory loads are pretty punishing to shoot.  Most folks are looking for a reduced load.
Logged

Offline dave hall

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 417
  • Gender: Male
  • The Great .458
Re: Reloading 45-70 & 500 S&W ?
« Reply #3 on: October 11, 2006, 05:32:19 PM »
quickdtoo,I thought where it said Ultra Rifle above it only fit that frame.If you can get it for the Handi that makes my day.My buddy will buy my 45-70.He doesn't like the kick of the 450.Does the 450 case eject as well as the 45-70.Thanks Swampman.I buy the big bores for the kick & the fill of the power I never use reduce loads if I could I would put the 50 Alaskan in one.Thanks for the info Dave.
Logged
NEF Handi SB2  .45-120 Sharps.
Stoeger Coachgun 20 Ga.
Ruger  SP101 4.2"  .357 Mag.
Rossi Ranch Hand (Mares Leg) 45 LC

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Reloading 45-70 & 500 S&W ?
« Reply #4 on: October 11, 2006, 05:47:19 PM »
Dave, I don't know about the .450M cases sticking, I really have no need for a .450M, I have three .45-70s and they never stick cases even when loaded to well above factory .450M loads. As far as sticking goes, the only time I have stuck brass is if the chamber is dirty/oily or I load too hot in other calibers. New barrels have extractors, so stuck brass should be a moot point in any caliber unless H&R still has some barrels left with ejectors.

All Handi/Ultra/BC/Target rifle barrels, frames and stocks will interchange, they all use the same components. The only difference tween an Ultra and a Handi is the stock set on current production. Older production had a nicer finish on the barrels, that doesn't seem to be true any more for any of my new Ultras, but I have a few pre '99 Ultras that have real nice barrel finishes on them. Ultras are made by or I should say they are marked Harrington & Richardson, Handis are made by or marked New England Firearms. Some NEF special/limited editions also have laminated stocks, but none are checkered that I've seen. All Ultras are checkered.


Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »