« previous next »
Pages: [1]   Go Down

Author Topic: I need some help!!!  (Read 483 times)

0 Members and 1 Guest are viewing this topic.

Offline Trout Bum

  • Trade Count: (0)
  • Member
  • *
  • Posts: 10
I need some help!!!
« on: October 11, 2006, 06:00:36 PM »
I purchased a 10" .22LR Bull Barrel that came with a scope mount but no rear sight.  I installed a bull barrel rear sight that I had laying around and headed to the range.  I was somewhat surprised to find that with the rear sight set as low as it would go, my point of impact was 6" higher than point of aim.

My question for those of you who have experience with Contenders, is there different rear sight heights or rear blade heights for these sights?  What sight should I be using?

Best regards,
Logged

Offline tlyne

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 271
Re: I need some help!!!
« Reply #1 on: October 12, 2006, 02:10:36 AM »
For a 10" contender 22LR barrel you need a "LOW" rear and a #6 front sight. T/C has three rear sights LOW, MED and HIGH. The #6 front  sight is .530" high.  I would call T/C and get a LOW rear sight. hope this helps, Twyman
Logged
Twyman

Offline Trout Bum

  • Trade Count: (0)
  • Member
  • *
  • Posts: 10
Re: I need some help!!!
« Reply #2 on: October 12, 2006, 05:41:12 PM »
Thank you Twyman, I will give them a call.  I was not aware of the different sight heights.

Thanks,
Logged
Pages: [1]   Go Up
« previous next »