« previous next »
Pages: [1]   Go Down

Author Topic: Sighting in receiver(peep) sight  (Read 438 times)

0 Members and 2 Guests are viewing this topic.

Offline heartman

  • Trade Count: (0)
  • Member
  • *
  • Posts: 33
Sighting in receiver(peep) sight
« on: October 23, 2006, 07:26:10 AM »
Just mounted a correct Williams peep on my Remington 700ML, and am having trouble getting the rifle to shoot on target.  At 25yds, just to get things started, I have my R & L just fine, but even with the peep moved all the way up the rear ramp, I'm still 4" low.  For the life of me I cannot remember if I need a taller or lower blade in the front sight slot - is that my problem?  I have a fair bit of experience, but not so much with peep sights...

Or, somebody could smack me upside the head with a 2X4, and tell me what to do... ::)

Thanks for any/all help here, folks.
Logged

Offline ScoutMan

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 287
Re: Sighting in receiver(peep) sight
« Reply #1 on: October 23, 2006, 09:04:38 AM »
Front sight rule: Make change in same direction as the error. In other words shooting low, you need a lower front sight.

Measure the height of the sight from the bottom of the sight to the top. Give this info to the company you want to buy your front sight from. I'm partial to XS sights. I would go to maximum width so that when I reached the "old geezer" stage I could still see the front sight. At MZ distances a wide front sight is no handicap.
Logged
If you can get closer, get closer
If you can get steadier, get steadier.

A telescope helps you see; it does not help you hold and squeeze.-Jeff Cooper

Offline heartman

  • Trade Count: (0)
  • Member
  • *
  • Posts: 33
Re: Sighting in receiver(peep) sight
« Reply #2 on: October 23, 2006, 09:56:35 AM »
Scoutman, I thank you.  And you didn't need to use a 2X4 either!  I'll check on the lower blade and PROCEED WITH CONFIDENCE! ;D
Logged
Pages: [1]   Go Up
« previous next »