« previous next »
Pages: [1]   Go Down

Author Topic: T/C Pachmayr and hammer spring  (Read 438 times)

0 Members and 1 Guest are viewing this topic.

Offline 7mmtcu

  • Trade Count: (0)
  • Posts: 4
T/C Pachmayr and hammer spring
« on: November 17, 2006, 02:24:47 PM »
I wanted to follow up on the issue of a Pachmayer grip causing an issue with the Contender hammer spring. I am not sure what to look for to tell if I have this issue. Any help would be great!
Thanks
Dean
Logged

Offline Gavinator

  • Trade Count: (5)
  • Avid Poster
  • **
  • Posts: 146
Re: T/C Pachmayr and hammer spring
« Reply #1 on: November 17, 2006, 08:52:22 PM »
 The end of the hammer spring that rests on the frame side gets longer as it's relaxed, with the hammer down on the firing pin look for clearance at the grip. If it doesn't have any, make some in the grip with a dremmel or a knife.
Logged

Offline 7mmtcu

  • Trade Count: (0)
  • Posts: 4
Re: T/C Pachmayr and hammer spring
« Reply #2 on: November 28, 2006, 04:13:01 PM »
Thanks for the help....opened them up with a Dremmel.
Regards,
Dean
Logged
Pages: [1]   Go Up
« previous next »