Author Topic: encore trigger and hammer extension (Read 728 times)

ENCOREROOKIE · « **on:** April 22, 2003, 03:36:37 PM »

just got my 223 stainless rifle in today....a few thoughts.....it felt real nice...I put a 6.5-20 X44 44 mag simmons scope on it with a harris bipod...gettin ready for the groundhogs..a few things i would like to get worked on...the trigger seamed real heavy..as expected from reading the board.....anyone tried a mike bellm trigger springs

or does anyone have any advice on what to do and i need a hammer extension....what are you all using...thanks in advance...the encore

rookie

Leon Garfield · « **Reply #1 on:** April 23, 2003, 02:03:15 PM »

Yes I have put the Bellm trigger springs in all my Encore's. Have also done the triggers on them and installed the Bellm oversize hinge pins and Bellm hammer ext.... Mike has it all check him out and he is more than willing to help you out.....

quicksdraw45 · « **Reply #2 on:** April 23, 2003, 02:18:17 PM »

I installed the bellm #4 spring and that brought my trigger pull to 1lb 14 oz ,It is nice and crisp with very little creep , He used to have intsructions on his websit on how to install it ,Its to easy .

ENCOREROOKIE · « **Reply #3 on:** April 23, 2003, 03:39:58 PM »

thanks guys..i was thinkin about ordering the springs...just needed someone to confirm it and that its not too hard to do...thanks...do you reccomend a hammer extension????I see where he sells them too