Author Topic: Rossi (Puma) .454  (Read 1321 times)

0 Members and 1 Guest are viewing this topic.

Swampman

  • Guest
Rossi (Puma) .454
« on: January 05, 2007, 01:35:11 AM »
I read a test report in Boar Hunter, and it was very favorable.  Do any of you have one, and do you like it?  Is it possible to improve the sights?

Offline 454Puma

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 539
Re: Rossi (Puma) .454
« Reply #1 on: January 05, 2007, 03:36:04 PM »
I have one and use the factory sites! Good enough for me ! The new one's you can get High vis site with them. ;D
One shot , One Kill

Offline TommyD

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 138
  • Gender: Male
Re: Rossi (Puma) .454
« Reply #2 on: February 06, 2007, 10:21:56 PM »
I have the Puma in 454, but didn't like the sights. My eyes didn't pick them up well. I will be 50 next year and they ain't what they used to be.

I replaced them with Marble's tang mounted peep sight and gold front bead. (http://www.marblesoutdoors.com/)

I am VERY pleased with the new setup.

I shoot primarily .45 Colt in the rifle and find it does best with heavier solid cast bullets (300+ grains) and slower powders like H110. My 1150 fps revolver loads break 1400 fps in the rifle. Easier on the shoulder than the "magnum" loads and more than adequate for most North American game in the lower 48. I don't live in Grizzly country, so that is not an issue for me.

Tom
--------------------------
NRA Life Member

Offline Warhawk

  • Trade Count: (2)
  • Member
  • *
  • Posts: 73
Re: Rossi (Puma) .454
« Reply #3 on: February 13, 2007, 06:49:34 PM »
Good writeup on the Rossi 454

http://www.gunblast.com/Paco_Legacy_454.htm

Offline Blowtorch53

  • GBO Supporter
  • Trade Count: (1)
  • Avid Poster
  • *****
  • Posts: 164
  • Gender: Male
Re: Rossi (Puma) .454
« Reply #4 on: September 03, 2007, 08:08:12 AM »
Swampman,

I put a rear peep on both my Pumas.  I have a .357 and .454.  I am too old to see barrel mounted sights.  Both mine worked without changing the front bead.  I think both of them had to be drilled an tapped but the newer ones may come like that.  Both are very accurate at 100 yds.  I bought the Williams from Midway for the 92.  It was about $40.  They have a more expensive version for about $20 more but these are fine on these rifles.  Look 'em up!

Good Luck,

BT53
"That God could and would if He were sought"