« previous next »
Pages: [1]   Go Down

Author Topic: Question for Quick...or Anyone Else  (Read 411 times)

0 Members and 1 Guest are viewing this topic.

Offline Cookiemann

  • Trade Count: (9)
  • Senior Member
  • *****
  • Posts: 1749
  • Apple Valley, MN
Question for Quick...or Anyone Else
« on: January 06, 2007, 08:35:11 AM »
Can you use brake parts cleaner on the nickle finish Tamer without discoloring it?  Posted this on the Rifle forum and didn't get a response.  Anything else I should or shouldn't do with the nickle??

cookie
Logged
NOT ON MY WATCH

"AIM small...MISS small"

Offline Topper

  • Trade Count: (0)
  • Member
  • *
  • Posts: 63
Re: Question for Quick...or Anyone Else
« Reply #1 on: January 06, 2007, 08:49:17 AM »
I used it on my TDC to clean the grease and filings out of the receiver when I first brought it home.  Of course you’ve got to wipe out the cleaner and wipe it down with an oily rag after.  Didn’t seem to hurt the finish on it.
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Question for Quick...or Anyone Else
« Reply #2 on: January 06, 2007, 08:54:36 AM »
I just tried some CRC Brakleen on mine, all it did was clean it and make it a little brighter!! I cleaned a spot on the inside of the frame first, just in case!! ;D

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline Cookiemann

  • Trade Count: (9)
  • Senior Member
  • *****
  • Posts: 1749
  • Apple Valley, MN
Re: Question for Quick...or Anyone Else
« Reply #3 on: January 06, 2007, 08:59:36 AM »
Shinier is good.  Mine has been sitting on the rack a few days and been handled a lot.  It could use a little shining up.  Thanks Tim and Topper for your help.

cookiemann
Logged
NOT ON MY WATCH

"AIM small...MISS small"
Pages: [1]   Go Up
« previous next »