« previous next »
Pages: [1]   Go Down

Author Topic: model 1896 swede timney trigger installation  (Read 478 times)

0 Members and 1 Guest are viewing this topic.

Offline 5.56er

  • Trade Count: (0)
  • Member
  • *
  • Posts: 75
model 1896 swede timney trigger installation
« on: March 06, 2007, 05:12:59 AM »
what is the best way for a the timney to be installed right now I have the screw rested against the hole underneath the receiver it is putting pressure on the screw is there a better way to have this hold, because I wnat it to be safe help appreciated
Logged
mauser 1895

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: model 1896 swede timney trigger installation
« Reply #1 on: March 06, 2007, 08:31:26 AM »
What model trigger do you have and what hole are you talking about? Timney triggers usually fit on the rifle easily.. If they don't I reccomend a call to Timney at the following toll free number - 1-866-484-6639. Their email is --
service@timneymfg.com
If the screw your talking about is the strain screw then there is likely a problem..
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline springer222

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 191
Re: model 1896 swede timney trigger installation
« Reply #2 on: March 06, 2007, 02:14:28 PM »
Had the same problem with one I did a few years ago. I used some shim material between the screw and the "hole" (on the bottom of the action). ONce you tighten up th screw against the shim material, it is held in place and not going anywhere. Has worked well ever since.
Logged
Pages: [1]   Go Up
« previous next »