« previous next »
Pages: [1]   Go Down

Author Topic: 243 lock up  (Read 355 times)

0 Members and 2 Guests are viewing this topic.

Offline flitz

  • Trade Count: (11)
  • Avid Poster
  • **
  • Posts: 206
  • Gender: Male
243 lock up
« on: March 24, 2007, 11:24:20 AM »
just recieved my barrel from darat100 which before that belonged to myarmor.
barrel is great.just to make sure the lock up is tight i want to ask a question.
i pu a piece of paper between barrel and reciever slammed it tight.cannot
pull paper out.this should be good to shoot with out any other fitting
correct?

flitz
Logged
TO THE HUNT

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: 243 lock up
« Reply #1 on: March 24, 2007, 11:38:11 AM »
Read my barrel fitting instruction in the FAQs, you need to check latch engagement too. ;)

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline flitz

  • Trade Count: (11)
  • Avid Poster
  • **
  • Posts: 206
  • Gender: Male
Re: 243 lock up
« Reply #2 on: March 24, 2007, 12:19:07 PM »
tim

smoked the latch.got a nice even line at about .037.even if this was not tottaly
correct i opened the calipers to .080 and it is way under that.hope i did this
right.

flitz
Logged
TO THE HUNT

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: 243 lock up
« Reply #3 on: March 24, 2007, 01:42:19 PM »
About .060"-.080" will work, closer to .060" would be ideal. Once the latch gets to the end of its travel as it wears the underlug, the barrel will be loose.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline flitz

  • Trade Count: (11)
  • Avid Poster
  • **
  • Posts: 206
  • Gender: Male
Re: 243 lock up
« Reply #4 on: March 24, 2007, 01:47:20 PM »
thanks tim

flitz
Logged
TO THE HUNT
Pages: [1]   Go Up
« previous next »