« previous next »
Pages: [1]   Go Down

Author Topic: Any one seen one of those Thermagic shotshell hull conditioner?  (Read 1517 times)

0 Members and 1 Guest are viewing this topic.

Offline Newly O'Brien

  • Trade Count: (0)
  • Member
  • *
  • Posts: 22
Any one seen one of those Thermagic shotshell hull conditioner?
« on: April 02, 2007, 05:25:41 PM »
Any one seen or used one of those NEW Thermagic shotshell hull conditioner.... an electrically heated reloading tool...  the Thermagic units "irons" out the fold and roll crimps in hulls.

Newly O'Brien
Logged

Offline PlacitasSlim

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 214
Re: Any one seen one of those Thermagic shotshell hull conditioner?
« Reply #1 on: April 04, 2007, 07:54:17 AM »
I have seen them in the BPI catalog, but have never used one. Seem to be the thing to do if going from a point crimp to a roll crimp. Otherwise I don't see a lot need for them. ;D
Logged

Offline Newly O'Brien

  • Trade Count: (0)
  • Member
  • *
  • Posts: 22
Re: Any one seen one of those Thermagic shotshell hull conditioner?
« Reply #2 on: April 04, 2007, 01:11:03 PM »
BPI carries it? ... are you thinking of the "spin doctor" instead of the "Thermagic"?

I was thinking, it would be idea for paper hulls and/or for those odd gauges..... other than 12g or 20g's (where there are tons of hulls available).

Logged

Offline .45 COLT

  • Trade Count: (1)
  • Contributor
  • ***
  • Posts: 319
Re: Any one seen one of those Thermagic shotshell hull conditioner?
« Reply #3 on: April 05, 2007, 03:17:40 AM »
I've never used one. It was written up in Handloader magazine (February 2007, I think). At around $80, it's a little to expensive for me to run right out and buy one. Bpi's conditioner works pretty good on plastics.

DC
Logged
On the 19th of April, 1775, a tyrannical government sent an army to disarm its citizens. They ran into a touch of trouble.
Pages: [1]   Go Up
« previous next »