SingleShotShorty - I wish I had seen your post a few years ago about the "short firing pin"; I got rid of a great shooting '81 BLR in a .308 that I couldn't rely upon to fire every time
. I did buy another (recently) in a .243 that also shoots very well and have found that it is "absolutely" necessary to insure all reloads are trimmed and sized "properly" or functioning in the field can be a problem (unlike a bolt that will overcome many problems encountered). Once I've run all the rounds through the action, like I'm sure most people do
, I'm good to go. The BLR (steel receiver) is one of the "slickest" handling and shooting rifles I've owned and the .308 is one of the best calibers for it of all the ones available, as far as accuracy and versatility (IMO). The only thing I've noticed of the caliber (could have been the many rifles I've had in this caliber) has been their habit of not throwing various weights of bullets into the same general group. I mean, every time I've switched from 150gr to 180gr the difference in impact seems to be several inches whereas my 30/06, .270, .35 Whelen will normally handle just about all weights within 2 to 2 1/2 inches of each other at 100 yards (some better). I've also seen the same problem with the .358, whereas the .243 seems to hold them closer together. Like I said, it could be the rifles I've used in them or some other factor, but that has been my experience. My solution has been to pick a particular weight of bullet and stick with it for all my game; the 165gr is my pick for the .308. I've found Accurate (AA) 2520, IMR4895, H4895, and RL15 to work the best in just about any .308 I've tried.