« previous next »
Pages: [1]   Go Down

Author Topic: has anyone done trigger work?  (Read 754 times)

0 Members and 1 Guest are viewing this topic.

Offline gooser

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 281
  • Gender: Male
has anyone done trigger work?
« on: August 12, 2007, 12:34:15 PM »
hello, i have a rossi .223 hb. the trigger sure could use some work, have you ever polished or done trigger work on your rossi rifle?
 ???
Logged
aim small miss small,
think small,miss not at all

Offline trotterlg

  • GBO Supporter
  • Trade Count: (36)
  • Senior Member
  • *****
  • Posts: 3978
  • Gender: Male
Re: has anyone done trigger work?
« Reply #1 on: August 12, 2007, 03:56:01 PM »
Yes, it is fairly easy.  You will have to make a couple of short pins to be able to assemble it again, but you basically just take the trigger and hammer out, hone a little off the sear area and put it back together.  I bet you can find detailed instructins some place.  If not I thik the Handi rifles have a very simular trigger.  Larry
Logged
A gun is just like a parachute, if you ever really need one, nothing else will do.

Offline gooser

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 281
  • Gender: Male
Re: has anyone done trigger work?
« Reply #2 on: August 13, 2007, 11:49:02 AM »
 ya, i am going to try that this winter,after all the woodchuck shooting is over for the year.I'd like to lighten it up to about 1 1/2 pounds or so.
 thanks

Logged
aim small miss small,
think small,miss not at all
Pages: [1]   Go Up
« previous next »