« previous next »
Pages: [1]   Go Down

Author Topic: Brownells,Bake on finish Insructions???????  (Read 554 times)

0 Members and 3 Guests are viewing this topic.

Offline billy_56081

  • GBO Supporter
  • Trade Count: (5)
  • Senior Member
  • *****
  • Posts: 8575
  • Gender: Male
Brownells,Bake on finish Insructions???????
« on: October 10, 2007, 04:59:40 PM »
After watching the instructions on using Brownells bake on finish I'm not sure I can use them to finish my barrel. The little video state to prep. the metal by bead blasting then degrease it. While I can definitely degrease the barrel I have no way to bead blast it. it will be a brand new chrome molly barrel in the white. Is it really necessary to bead blast? Or should I use there alumahyde II finish?
Logged
99% of all Lawyers give the other 1% a bad name. What I find hilarious about this is they are such an arrogant bunch, that they all think they are in the 1%.

Offline EVOC ONE

  • GBO Supporter
  • Trade Count: (3)
  • Senior Member
  • *****
  • Posts: 1373
  • Gender: Male
Re: Brownells,Bake on finish Insructions???????
« Reply #1 on: October 12, 2007, 12:31:41 AM »
I've not tried the bake on finishes.

I have used Aluma Hyde II on several occasions and like it very much.  It goes on thick, so care is need around tight fitted parts and areas.
Logged

Offline whynot

  • Trade Count: (0)
  • Member
  • *
  • Posts: 10
Re: Brownells,Bake on finish Insructions???????
« Reply #2 on: October 12, 2007, 04:38:37 PM »
I've had good luck by  roughing  the surfaces with 120 grit sandpaper. I have one shotgun prepped this way over 20 years ago, still on there.

On just the barrel, cut the paper into 1" strips and use a "shoe shine" action to rough the surface.
Logged
Pages: [1]   Go Up
« previous next »