« previous next »
Pages: [1]   Go Down

Author Topic: Shilen or Walther?  (Read 567 times)

0 Members and 1 Guest are viewing this topic.

Offline osix

  • Trade Count: (0)
  • Member
  • *
  • Posts: 8
Shilen or Walther?
« on: October 19, 2007, 01:55:19 PM »
I'm about to re-barrel an Browning FN Mauser to 338 mag, not sure which way to go with the barrel.
Shilen or Walther, not sure which is the better barrel?.
The other option is pre- chambered or not.
Think the Shilen thread is a v cut at 12 tpi, would this be suitable?
Many Thanks
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Shilen or Walter?
« Reply #1 on: October 20, 2007, 07:13:58 PM »
Have had very good luck with shilen, esp. the match grade.. Haven't used a lot of Walther, those I know of who have used them were quite satisfied..
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline gwindrider1

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 446
Re: Shilen or Walther?
« Reply #2 on: October 29, 2007, 03:15:20 AM »
Either one is a fine choice.  Harry McGowen also makes one hell of a barrel, and will install it for you as well. 

Best of luck with your new .338!  Your going to like that chambering.
Logged

Offline tnekkc

  • Trade Count: (0)
  • Member
  • *
  • Posts: 29
Re: Shilen or Walther?
« Reply #3 on: November 17, 2007, 07:45:41 AM »
Stainless LW are are of a tougher SS that is hard to get a smooth throat.
Chrome Moly Shilen are not routinely lapped and have rough bores that Copper foul.

What does it all mean?
CM get LW
SS get Shilen

I have plenty of Shilen CM, and never again.
Logged
Pages: [1]   Go Up
« previous next »