« previous next »
Pages: [1]   Go Down

Author Topic: RCBS 7.62-130  (Read 412 times)

0 Members and 1 Guest are viewing this topic.

Offline WayneS

  • Trade Count: (13)
  • Contributor
  • ***
  • Posts: 490
RCBS 7.62-130
« on: October 25, 2007, 03:11:02 PM »
RCBS says this mold is for the 7.62x39 and has a as cast dia. of .310 /.311.  Just wondering if anyone has tried this in a standard .308 bore fire arm. ??
Logged

Offline jhalcott

  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 1869
Re: RCBS 7.62-130
« Reply #1 on: October 25, 2007, 06:11:19 PM »
  I have several Lee molds that cast a bit OVER the stated size. I run them thru the sizer and they work fine. That 130 grain bullet should work fine in any .30 caliber gun. YOU just have to find the correct load.  Plus the fact that an alloy with more pure lead USUALLY casts a smaller diameter bullet.
Logged

Offline WayneS

  • Trade Count: (13)
  • Contributor
  • ***
  • Posts: 490
Re: RCBS 7.62-130
« Reply #2 on: October 25, 2007, 06:48:04 PM »
Thanks, I wasn't really concerned about the.310 dia as I size my bullets with a  .310 die for my contender. I'm just concerned about  none of the nose being bore riding because I need about 2 MOA for what I want to use it for.
Logged
Pages: [1]   Go Up
« previous next »