« previous next »
Pages: [1]   Go Down

Author Topic: Fit and Finish  (Read 242 times)

0 Members and 2 Guests are viewing this topic.

Offline PWalker

  • Trade Count: (1)
  • Member
  • *
  • Posts: 42
  • Gender: Male
Fit and Finish
« on: December 28, 2007, 04:05:35 PM »
After seeing several of the cinnamon laminate stocks adorning these rifles,I have the itch.I read where Tim said that the thumbhole lams weren't available at present time.Are the stocks from Brownells close in quality to the H&R factory laminates.I want something I can bolt on and not have to sand or fit.Is it just me or can anybody else not see pictures of the laminate stocks on Brownells website????
Logged

Offline PWalker

  • Trade Count: (1)
  • Member
  • *
  • Posts: 42
  • Gender: Male
Re: Fit and Finish
« Reply #1 on: December 28, 2007, 04:10:58 PM »
I looked at the websitea little closer and see that H&R makes the stocks for Brownells.....No thumbholes though
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43300
  • Gender: Male
Re: Fit and Finish
« Reply #2 on: December 28, 2007, 04:14:04 PM »
They ARE the H&R factory stocks, Brownell's sells a lot of their parts, I just ordered all of the ejector parts for an extractor to ejector conversion. Sorry, no thumbholes, the Boyd's are only available on complete rifles and thru H&R, although BC Pawn sells some on Ebay too, his may very well be seconds or come without pads, several members were very dissatisfied with his stocks.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »