« previous next »
Pages: [1]   Go Down

Author Topic: Ruger Grip Frames  (Read 577 times)

0 Members and 1 Guest are viewing this topic.

Offline Heavy C

  • Trade Count: (7)
  • Senior Member
  • *****
  • Posts: 1088
  • Gender: Male
Ruger Grip Frames
« on: January 29, 2008, 06:52:49 PM »
I have a Ruger Blackhawk project gun I'm working on and I want to swap out the grip frame.  Do you guys know where I can find some instructions on how to do this?  I know Brownell's has schematics.  Any suggestions?

Thanks,

Heavy C
Logged

Offline BlkHawk73

  • GBO Supporter
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1501
  • Gender: Male
Re: Ruger Grip Frames
« Reply #1 on: January 30, 2008, 11:48:59 AM »
  Pretty easy sap.  Loosen and remove the screws and carefully take it apart watching for any small springs to fall.  there's a spring/plunbger on the underside of the frame for the cylinder latch and one in the top rear left side grip frame also.  Just looking at the schematics is plenty to see. 
 Just a FYI, if it's an unfinished gripframe, it'll need some fitting for the width. 
Logged
"Never Surrender, Just Carry On."  - G.S.

Offline Heavy C

  • Trade Count: (7)
  • Senior Member
  • *****
  • Posts: 1088
  • Gender: Male
Re: Ruger Grip Frames
« Reply #2 on: January 30, 2008, 12:08:15 PM »
Thanks BlkHawk73.  I went ahead and removed the grip frame that was on there last night.  I saw both of the springs you mentioned.  The cylinder latch spring:  I saw where if fits in the grip frame, but is there a slot or hole if fits into under the latch?
Logged
Pages: [1]   Go Up
« previous next »