pro hunter hammer

[chumbo]

Will a hammer from a pro hunter fit an encore? I am thinking of swapping out the original hammer on my 7MM with one from a pro hunter. No need for hammer extension if it will swap out. The scope I have does not have a lot of clearance between hammer and scope. Setting the hammer off to on side would be nice. I took the trigger assembly out and honed all of the casting marks from the mating surfaced and it does make a difference. Did not change any pull weight or springs, just smooths every thing out.   

[sportsman223]

 Yes it will fit, but you have to send the frame into TC to get it changed. They will not sell the hammer any other way I think it cost about 50.00 look on there web site. I had mine done last year. Look at the 20g post a few post's down there is a picture of mine

[quickdtoo]

It'll cost $69.95 for the conversion.

Tim

http://www.tcarms.com/customerService/

The bad part....
If you have had any custom work done i.e.; a trigger job etc., your firearm will be sent back to you at factory specifications; however we will return your customized components.