« previous next »
Pages: [1]   Go Down

Author Topic: Cannon vid  (Read 486 times)

0 Members and 1 Guest are viewing this topic.

Offline Owen

  • Trade Count: (0)
  • Member
  • *
  • Posts: 75
Cannon vid
« on: February 11, 2008, 03:16:51 PM »
Not sure if you have seen this

Owen.

[yt=425,350]http://www.youtube.com/watch?v=hYWDuXadosA[/yt]
Logged
Artillery lends dignity to what would other wise be a vulgar brawl.

Offline Owen

  • Trade Count: (0)
  • Member
  • *
  • Posts: 75
Re: Cannon vid
« Reply #1 on: February 11, 2008, 03:18:12 PM »
Logged
Artillery lends dignity to what would other wise be a vulgar brawl.

Offline KABAR2

  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 2830
Re: Cannon vid
« Reply #2 on: February 11, 2008, 03:56:20 PM »
They make it look so easy! These two fellows are masters in their craft!

Years ago I had my  own forge and did some blacksmithing the hardest thing I found
was trying to forge weld, it took a lot of  hours of trial and error to get a weld right!
these two  make it all look easy.  :o

are there any more videos of them test firing ?

Thanks for sharing!

Allen <><
Logged
Mr president I do not cling to either my gun or my Bible.... my gun is holstered on my side so I may carry my Bible and quote from it!

Sed tamen sal petrae LURO VOPO CAN UTRIET sulphuris; et sic facies tonituum et coruscationem si scias artficium

Offline accuratemike

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 138
    • http://www.accuratepower.com
Re: Cannon vid
« Reply #3 on: February 12, 2008, 11:21:30 AM »
I posted the link on IForgeIron, the blacksmith types are drooling a bit too. My son and I just built a forge ( www.accuratepower.com/FrogPondForge ), but I think we have a way to go before we tackle one of those. Thanks for the heads-up. MIKE
Logged
Pages: [1]   Go Up
« previous next »