RUGER TRIGGER SPRING QUESTION BISLEY 41 MAG:

[lonewolf5348]

The trigger spring?
can it be removed without taking out the main spring I would like to replace it with a lighter spring from Brownells
brownells sell
30oz
40 oz
here the spring with a little bend on it for lighter trigger pulls
I got it down to 56 oz. not bad compared to 5 1/2 pounds from the factory.
I think by removing the small drift pin in the lower part of the frame(Trigger Spring Pivot Pin,) the spring should come out;I thought I ask.I tried the pin threw the main spring rod and let the hammer down but still can't remove the mainspring rod from the frame.
I bent only the the legs that hook in the frame so I did not remove the complete spring yet

[BlkHawk73]

  Could be yes I suppose but removing the main hammer spring assembly is an easy task.  Use ahex wrench in the hole to hold it under tension and it comes out and goes back darn easy.

[warrior1]

with my blackhawk,i had to take her apart,and without lookiin the directions are in your
manual. seems   i had to do it three times before i got it right.
the thing is if i can do it anybody can. follow your manual. if you do not have one you should be able to print one off of ruger"s sight. good luck dan

 

[lonewolf5348]

I have to say I had a hammer spring assembly that gave me a problem to remove but I did remove it and installed the new trigger spring from brownells did improve the break to 45oz
I did notice the crane scratch on the cylinder is more noticeable then my  other ruger in 22 cal. mag:
Timing seem to be o.k.
any ideas