« previous next »
Pages: [1]   Go Down

Author Topic: SRH 44 Cylinder Throat and Bore Diameter for Mold order purposes  (Read 796 times)

0 Members and 1 Guest are viewing this topic.

Offline FreeNHim

  • Trade Count: (13)
  • Member
  • *
  • Posts: 55
  • Gender: Male
SRH 44 Cylinder Throat and Bore Diameter for Mold order purposes
« on: April 29, 2008, 02:47:11 AM »
I'm hoping to get into casting my own bullets for my SRH, and would like to purchase a mold. Is there a generally recognized standard cylinder throat/ bore diameter that can be used?  I was not sure if I should go with .431 or .432?  I guess I should really slug both to find out if there is a lot of variance.  Any advice would be appreciated.  Thanks!  Jim
Logged

Offline Lone Star

  • Reformed Gunwriter
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2359
  • Gender: Male
Re: SRH 44 Cylinder Throat and Bore Diameter for Mold order purposes
« Reply #1 on: April 29, 2008, 04:20:52 PM »
The default for best accuracy/least leading is to match the throat size within 0.001" or less.  But check the bore diameter - if it is much larger than the throat, accuracy will suffer and leading may occur sooner.  Unfortunately this happens more often than it should - two of my own Rugers were so afflicted.  The solution then is to ream out the throats to match the bore and cast accordingly.


.
Logged
Pages: [1]   Go Up
« previous next »