Author Topic: ruger super redhawlk alaskan 44 mag  (Read 380 times)

0 Members and 1 Guest are viewing this topic.

Offline woods

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 185
  • Gender: Male
ruger super redhawlk alaskan 44 mag
« on: May 13, 2008, 04:51:07 PM »
I purchased a super red-hawk Alaskan in 44 mag. Now I am searching for a few loads for it. I have a couple pinker loads picked out, now I looking for a few 250 gr and up loads for hunting at close range under 30 yards. I don't own a chronograph so I can't really check velocity on my loads. Out of a 2 1/2" barrel I know the velocity is slow I'm looking for some load data that is tailored to the short barrel of this 44. I was hoping someone would have a source or a load they have tested and checked out that is listed in the load manual that is safe. The other 44 I have is in a ruger 44/96 I have a couple deer loads I like for it but I would like to shoot the same rounds in both so it could be interchangeable. I reload about everything I own. so factory stuff is not really a option.

woods

Offline ricciardelli

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1004
  • Gender: Male
    • http://stevespages.com/page8.htm
Re: ruger super redhawlk alaskan 44 mag
« Reply #1 on: May 13, 2008, 11:26:57 PM »
I haven't done testing with a 2-1/2" barrel in the .44 Magnum.  But I have with a 4" and a 7-1/2" barrel, using identical loads, the 4" barrel averaged velocities around 100 FPS slower than the 7-1/2".

(4" was an S&W 29, and the 7-1/2" was a Ruger SBH.)

Offline PaulS

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1120
Re: ruger super redhawlk alaskan 44 mag
« Reply #2 on: May 15, 2008, 10:46:06 AM »
Try this load for your hunting load:

WW case trimmed to 1.290"
20.4 grains of H110
Speer Gold Dot 170 grain
Seated length of 1.590"
Use a solid crimp in the bottom of the groove.
velocity: 1280 fps
produces 1.5" groups from Ruger Blackhawk at 100 yards from a rest.
PaulS

Hodgdon, Lyman, Speer, Sierra, Hornady = reliable resources
so and so's pages on the internet = not reliable resources
Alway check loads you find on the internet against manuals.
NEVER exceed maximum listed loads.