« previous next »
Pages: [1]   Go Down

Author Topic: 9MM Cast Bullet Dia.  (Read 336 times)

0 Members and 1 Guest are viewing this topic.

Offline winman

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 151
9MM Cast Bullet Dia.
« on: June 15, 2008, 03:28:45 PM »
I have some 147 grain cast 9MM bullets that measure .358 with my dial calipers. The box even says 9MM and .358 but I'm thinking maybe I should use them in a .38 and look for some .356 dia's for my 9MM loads. The owner of the indoor range where I shoot limits loads to 900 fps so I want a load that will cycle my 9MM action and still be under 900 fps. Think I could do this by using 147 grain cast bullets and 3.5 to 3.8 grains of 231?  Thanks.   
Logged

Offline Lloyd Smale

  • Moderators
  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 18267
Re: 9MM Cast Bullet Dia.
« Reply #1 on: June 16, 2008, 12:41:29 AM »
ive shot 358s in mine. Some will feed them just fine and some wont. But most of the time i size to 357 for the 9s and 358 for the 38s. They will work fine in your revolver.
Logged
blue lives matter

Offline blackpowderbill

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 287
  • Gender: Male
Re: 9MM Cast Bullet Dia.
« Reply #2 on: June 17, 2008, 04:03:05 AM »
I have used .355 to .358 lead bullets in my 9mm with no differences and no signs of pressure issues.
Logged
People are like slinkies, they serve no purpose yet they bring a smile to your face when you push them down the stairs.

Offline winman

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 151
Re: 9MM Cast Bullet Dia.
« Reply #3 on: June 17, 2008, 10:37:09 AM »
Quote from: blackpowderbill on June 17, 2008, 04:03:05 AM
I have used .355 to .358 lead bullets in my 9mm with no differences and no signs of pressure issues.

Thanks, that was my concern.
Logged
Pages: [1]   Go Up
« previous next »